Congrats! Best engineered, dyno, just bought-proof of receipt, you can use the system. Please check this box, the contents immediately. Any defects or missing parts of the report, this Injen technology certified dealer you bought the product. This is all part of the system thoroughly prior to installing, please read the instructions. If you have any questions about installing this product, please contact your application vendor. Setup does not require any mechanical skills. It is always the most qualified mechanics. * Engine is hot while trying to install the intake system. Install the radiator fluid line that could be the hot to get rid of, you can ask for. Injen technology, material, and offered limited lifetime warranty for the original purchaser. Warranty claims must be handled through the dealer you purchased items.
Note: before you begin the installation, remove the negative battery teriminal.
1 air intake box cover and intake air intake duct leading to the throttle body.
2 remove the 6 mm hose replace valve water bypass-21 "as shown in Figure 4, PCV pipe Kit. Coolant line located on the entrance to the port is the manifold housing. Diagram of A or B, the location of the coolant hose line port of your car can vary depending on the year. (Do not touch your engine is cold, remove all lines until you have.)
3 remove all ex-model 94-97-all of the components as shown in the diagram of the C-# 8. Cold air intake applications are not used in this program, since air resonance box may remain in the inventory location. EGR valve, remove a component from a pipe leading to the metal lid to seal off the line might have been once 5mm vacuum Cap with figures 6 and the plug as shown in the diagram in C..
4 as you can see in Figure 3, the vibra-mount the fender wall screws and nuts and washers, m6.
Step 5 use the clamp on the hose throttle body and control knob on the body and two clamps to tighten at this point. Please refer to figure 2.
6 1/2 "aluminum nipples at the end of a three-phase with the intake hose" nut and clamps and placed towards the vibra-Stud and snaps the brackets on the intake semi-tighten. 5 and 7 refer to the Figs.
No comments: