Required accessories tool needed to remove radio radio wire is required to complete this install new hand tools tools plus: wire ties or electrical tape: neatly bundle and professional appearance in cleans wires. Tool tips: small battery: battery, test the speaker wire. (+) Touches the "pop" sound, positive and a pair of speakers to the speaker (-) negative leads a pair of wires that caused the baterry speaker goes to represent. Before creating a voltage meter: wire connection + 12-volt power wire, check the voltage at all times. These fluctuate between 10 and 14 Volt wire. In the wire solder iron or wrinkle tools: wire connection using one of the soldering iron and electrical tape or plastic found in most of the wrinkles or auto parts store the Terminal hardware.
Step 1: you must pull the radio and dash center console loosely around the plastic dash Panel to access the screws securing the away. Center console glove box. At the very bottom is a plastic Panel that covers the screws are hidden. Finger or flat-head screwdriver, remove the plastic Panel with a lift. Panel is removed, locate and remove the screws with a Phillips (2).
Step 2: open the door and lift the beverage tray. Beverage tray and pull and pull out the center console.
Step 3: once the drink tray, remove and then reinstall the two screws finds 3 (2) and (3) Phillips screws are hidden under the center console. Center console and pull back the plastic gear shift, away from the Phillips retaining screws from the console trim. Gear shift surrounds the Panel. (2) screws two screws at the bottom of the Panel. And you only need to pull the center console near the top left hand corner of the back opening on the front (1). 2-3 inches as you can see from the photos above.
No comments: