Special instructions for air communications
1. Cut the pipes correctly the launch must be used (not scissors)
2. Inserting tube in it must be pushed in about 14 mm until you hear a click.
3. to remove the tube, then the flange connection and at the same time pull tubes. (No tool needed).
4. the attention of the tube is removed, it is important to trim 14 mm from the end to reestablish the connection.
5. it seems appropriate to use LOCKTITE on the screw fittings.
Important
• Installation Guide should be read prior to Assembly.
• This set does not increase g.v.w. (gross vehicle weight) of your car, for your safety and to avoid any damage to your vehicle does not exceed the maximum load recommended by the manufacturer.
• Do not inflate the airbag Assembly.
• After installation kit does not exceed the Max and min pressure, misuse or over inflation could worsen your pendants.
No comments: