To remove (3) screws holding the front fascia inside the radiator opening below. Next remove the screw on both sides. These are the screws that hold the bottom of the bumper cover. See the plastic push pins remove Photo (2) holding the bumper beam radiator Shroud. Remove (2) plastic latches on each side of the radiator Shroud. Guide the side wings of the radiator Shroud around the brackets for the last (2) screws that were removed. Remove the shroud of topside, pushing back the capacitor as necessary for settlement. If the shroud does not clear the bumpers while removing it may be easier to free her from under the side of the vehicle. Thoroughly clean the Shroud to ensure adherence of the tape to the next step.
Disconnect the electrical connector for under hood light & remove the electrical connector for under hood light from the radiator Shroud. Unplug the electrical connector outside air temp sensor located at the bottom on the right side of the Shroud. Remove the 2 push closures "Christmas tree" by holding the radiator Shroud the capacitor. They lie approximately halfway up along each side. Raise the front of the vehicle, follow the manufacturers instructions. Use Jack stands to support the vehicle. pdf SCIC Magnuson Supercharged Corvette C6 airbox application installation instructions
Get
No comments: