This product will be in stock the Honda s 2000 lap belt and shoulder harness if and only if it is intended to provide increased driver support. It can be used as a replacement or for all events competition belt 4 or 5 point restraint system is not required. This product is an electric magnet built into the Assembly using the belt inertia-sensing mechanisms that enable the plant In any way, you do not change the regulatory system in the plant, and the belt or airbag system is not affected. It is simply one usually kicks when you corner or a safety belt is built on hard work breaks, "tilt" mechanism is activated. Modifrys belt Lock is relatively easy to install and can be removed quickly, leaving a trail there.
Installation
1. preparation-sat on the trunk or break (really) can get in the way of the empty the trunk of anything. Remove the access panel and spare tire spare tire. Then, slide and tilt the passenger seat as far as it will go forward. Note-the electro-magnet bracket attached black belt for locking, use the abbreviation "SBL".
2. remove the access panel behind the passenger seat. Two plastic hooks screws remove the screws and the cover snaps. Outside, start at the bottom and clip into place gently work around the outside edge of the task panel.
3. Locate the accessory power socket wire harness. This wire goes on the right side under the glove box on the loom. Pry-apart plastic (which is split down the middle) and T-tapping attachments in preparation for the black and white/red wire pulled out. Two wires are not black and white/red, you have the wrong wire loom stop.
No comments: