2004 HONDA ELEMENT KEYLESS ENTRY INSTALLATION MANUAL

PART LIST : 2 Transmitters, Receiver unit, Bracket, Flange bolt, Owners manual

TOOL AND SUPPLIES REQUIRED : Ratchet, 10 mm Socket

INSTALLATION INSTRUCTIONS : 1. If equipped, make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. Remove the drivers dashboard lower cover, turn the knobs clockwise, then pull the drivers dashboard lower cover out toward you to release the six retaining tabs. 4. Slide the bracket onto the receiver unit. If the vehicle is equipped with an XM radio, refer to the XM radio installation instructions for the installation procedure to install the receiver unit. 5. Position the bracket on the steering hanger beam and install the flange bolt supplied. 6. Locate the 5-pin connector blue-taped to the vehicle harness and remove the blue tape to free the 5-pin connector. Plug the 5-pin connector into the receiver unit. 7. Check that all wire harnesses and cables are routed properly and all connectors are plugged in. 8. Reinstall the drivers dashboard lower cover. 9. Reconnect the negative cable to the battery. 10. Enter the customers radio anti-theft code, if applicable, and reset the radio station presets. 11. Reset the clock. 12. Check operation of the keyless entry according to the Owners Manual supplied. NOTE: Whenever the battery is disconnected, the drivers window AUTO function is disabled. 13. Start the engine. Push down on the drivers window switch until the window is fully open. 14. Pull up on the drivers window switch to close the window completely, then hold the switch for 2 seconds or more. 15. Lower and raise the drivers window to check the operation of the drivers window AUTO function.