It is better to park on the flat surface, like you do, docking it on the hand brake and shift out of gears to neutral. If you cant do this responsibility to install bearings on a slightly inclined cable moving, place wooden blocks in front of or behind the wheels to prevent the vehicle moving while you work.
Estimated installation time: 30 minutes
Necessary tools:
? Ratchet
? 10 mm deep socket
? Ratchet extension
? A needle nose pliers, it know
Device:
1. Engine Bay work, two terminals with a battery screwdriver ratchet socket 10 mm. remove the battery tie-down with a 10 mm deep socket for the two bolts. Remove the throttle cable from the bracket as shown on the left. Notice how the battery tie down, put it on the side for re-installation with the later.
2. remove the battery and the battery plastic tray engine Bay. Put them aside in a safe place for re-installation with the later.
3. start removing absorption by loosening the bolt is marked to the right socket, 10 mm Ratchet and disconnect the inlet tube from the air. Disconnect the two bold image sensors from the air. Unclip the two latches in the air. Remove the top of the air box and filter the air access to the bottom of the air. Put them aside for re-installation with the later.
4. remove the three bolts at the bottom of the air box with 10 mm socket with ratchet. Put them aside for re-installation with the later.
5. open the door to the reception holding lightning near the drivers side headlight with 10 mm socket with ratchet. Remove the bottom of the engine Bay and reception for re-installation with him aside later.
6. you now have access to two cables bearings. Remove the cotter hslalom with needle nose pliers, tongs. Also remove washers holding the metal bearings rubber stock. These washers is not used again, but you must save the return in case of future stock lmisbim
7. Remove rubber bearings to move cables. stock You can use the pin on the arm the broadcast (including hairpin cotter was connected) to force the bearings out of moving the cables. Use the provided to clean the pins with a fruitful, and also within the loop the cable if there is corrosion. These bearings will be reused, but you must save the return in case of future stock lmisbim
No comments: