To help you find your way this guide, get the title and first section at the top of every page. The index is published on the first of each section to guide you to the correct item. At the beginning of each section, given precautions for all repair actions are included in this section. Read these safety precautions before beginning any activity. Troubleshoot tables are included for each system to help you diagnose the problem and find the cause. Patch for each possible cause is referenced in the medicine to lead you quickly to the solution.
How to use this guide
The procedures shown step-by-step format: #
• The illustration shows what to do and where to do it.
• Job title tells what todo.
• Detailed text reveals how to perform the task and provides additional information such as specifications and warnings.
This template provides the experienced technicians with fast track to the required information. You can read the task title capitalization at a glance when necessary, and provides detailed information under text. Important specifications and warnings always highlight in bold.
General repair instructions
1. use floor covers, fender and seat to keep the vehicle clean and prevent damage.
2. during the liquidation, save parts to facilitate reassembly.
3. consider the following.
(A) before performing the electrical work, disconnect the negative cable to the battery terminal (—).
(B) If you need to disconnect the battery for a test, or a repair, always disconnect the negative cable terminal (—) which is incorporated into the body.
(C) to avoid damage to the battery terminal, Terminal nut en los raise the cable straight up without prying or warp it.
(D) clean the battery terminal posts with cable oil rag shop. But not just them with a file or other object ??????.
(E) install Terminal battery cable post and tighten the nut with a nut free after Setup. Do not use a hammer to the console press the post. (F) be sure that the positive (+) end of the lid properly in place.
4. check the hose and connectors wiring to ensure they are correct and secure.
5. the parts that can be used non-reuse
(A) always replace the cotter pin, gaskets, O-rings, oil seals, etc. the new one.
(B) usable non-repeating parts are marked with a "?" component illustrations.
No comments: