VAUXHALL/Opel Corsa 1.2, 1.4 Spi 60BHP 1993-99 57-0298 instruction sheet A2054 796-1 of 2 page, please read the instructions before fitting kit. Note: the Kit is suitable for both models. Photo photo A B 1. Unclip and remove the hose from the intake air box Assembly. 2. remove the air box hot air flap vacuum hose from the rear of the intake housing. Empty the vacuum exhaust pipe with rubber plugin comes. 3. Unclip and remove the intake scoop of the cross-member and the air box Assembly. 4. remove the hose from the manifold exhaust and air box hot air flap. 5. remove the air box Assembly from the mounting rubber, and then slide the Assembly mounting bushings at the rear. Remove the Assembly from the car. 1. Fit the new mounting bracket with the original rear air mounting grommet
use large washers, spring Washer, flat washers, nuts and screws that are provided in the kit. 2. Fit the metal pipe down to step in the filter. Do not push for the step, as it will affect the flow of air. Until the filter simply turns tighten studded clip on filter. 3. Fit the filter Assembly in hose firmly tighten withdrawals and new video available. 4. attach the clip to the new bracket is studded with flat washers, spring Washer and nut comes. 5. rotate the filter thus K & N logo directly then tighten the clip one full rotation (360 degrees) is not more not overtighten clip. 6. Carefully extend hose cold air for approximately 64 cm/25 ". Feed the hose down between the plastic decoration next to the radiator in the Front grille. Attach at the top of the flexible hose cold air hose top coolant with long plastic tie. Cold-flexible air hoses position so that it points to the filter and 10 cm/4 "away no closer. Your car and engine Bay should look at these photos, if not ...
No comments: