The installation procedure:
1. screwdriver power shift is by rotating the picture counter clockwise.
2. use a Phillips head screwdriver to remove the 2 screws on both sides of the console behind the shift boot. Fully rearward sliding seats allows easy access because these ??????.
3. the front seats slide forward fully and use screwdriver Phillips head screws to remove the 2 sides of the back of the center console.
4. lift the rear of the center console of the car and a safe place for re-installation with.
5. Locate the clips on the front top of the center console. Gently push in the center portion of these clips, then pull finger or screwdriver to remove them.
6. pull the stereo out around the plate a little to make the front part of the console.
7. use the needle nose pliers, tongs to detach the clip holding the power connector plugs to a steel bracket.
8. disconnect electrical connector plugs on the front of the console.
9. now you can remove the front part of the car center console. The drawing up and out of the car, rear.
10. use the flat screwdriver head fetish clip of the driver of the Assembly of the shaft. Use caution during this phase as the clip may break and become a dangerous projectile. Use the screwdriver on the wedge it between the plastic clip, gradually work it off the shaft. Alternatively, Dremel tools may be used to cut the new clip is included in the set.
11. remove the clip from the "L" shaped arm and the cable off his arm on the side.
No comments: